How to Set Up Jumper T8SG Plus for Helicopters

Step 1 Configure Gyro.

If your gyro is not configured, you will not get any servo inputs

Step 2 6Ch Heli Template

After turning on transmitter, press under key to get to the Main menu. From there select “Model Menu” > “Model Setup”. Where you see Load, press right key until you see “Template”. Press enter then scroll down to “6Ch Helicopter”.

Step 2 Control Check

Back out to “Model Menu” then go to “Mixer”. Confirm your Aileron servo moves when you give aileron input on your transmitter. If a different servo moves, switch where the servo is plugged in on your gyro. If Aileron input causes the Elevator Servo to move, swap the Cyclic1 to Cyclic2 or the Cyclic2 to Cyclic1.

Aileron mapped to Cyclic2. I opted to not switch the location of the servo leads on the gyro and changed the mapping on the transmitter instead.

Step 3 Get Cyclic to Work

To get your collective pitch to be linked with throttle, Cyclic3 should be wherever you plug your gyro into your receiver.

Cyclic3 mapped to a reversed Ch5